The existing version constraint uses logic optimized for package
managers, not schedulers, when checking prereleases:
- 1.3.0-beta1 will *not* satisfy ">= 0.6.1"
- 1.7.0-rc1 will *not* satisfy ">= 1.6.0-beta1"
This is due to package managers wishing to favor final releases over
prereleases.
In a scheduler versions more often represent the earliest release all
required features/APIs are available in a system. Whether the constraint
or the version being evaluated are prereleases has no impact on
ordering.
This commit adds a new constraint - `semver` - which will use Semver
v2.0 ordering when evaluating constraints. Given the above examples:
- 1.3.0-beta1 satisfies ">= 0.6.1" using `semver`
- 1.7.0-rc1 satisfies ">= 1.6.0-beta1" using `semver`
Since existing jobspecs may rely on the old behavior, a new constraint
was added and the implicit Consul Connect and Vault constraints were
updated to use it.
* jobspec: breakup parse.go into smaller files
* add sidecar_task parsing to jobspec and api
* jobspec: combine service parsing logic for task and group service stanzas
* api: use slice of ConsulUpstream values instead of pointers
IOPS have been modelled as a resource since Nomad 0.1 but has never
actually been detected and there is no plan in the short term to add
detection. This is because IOPS is a bit simplistic of a unit to define
the performance requirements from the underlying storage system. In its
current state it adds unnecessary confusion and can be removed without
impacting any users. This PR leaves IOPS defined at the jobspec parsing
level and in the api/ resources since these are the two public uses of
the field. These should be considered deprecated and only exist to allow
users to stop using them during the Nomad 0.9.x release. In the future,
there should be no expectation that the field will exist.
Fixes#3380
Adds address_mode to checks (but no auto) and allows services and checks
to set literal port numbers when using address_mode=driver.
This allows SDNs, overlays, etc to advertise internal and host addresses
as well as do checks against either.
Ideally DriverNetwork would be fully populated in Driver.Prestart, but
Docker doesn't assign the container's IP until you start the container.
However, it's important to setup the port env vars before calling
Driver.Start, so Prestart should populate that.
Michael Schurter